Some of the configurations used in amplifier circuits are It can amplify power, voltage and current at different configurations. The value of I B should not exceed mA.Ī Transistors acts as an Amplifier when operating in Active Region. Where, the value of V BE should be 5V for BC547 and the Base current (I B depends on the Collector current (I C). The value of this resistor (R B) can be calculated using below formulae. Anything more than 5mA will kill the Transistor hence a resistor is always added in series with base pin. ![]() As mentioned the biasing current should maximum of 5mA. As discussed a transistor will act as an Open switch during Forward Bias and as a Closed switch during Reverse Bias, this biasing can be achieved by supplying the required amount of current to the base pin. When a transistor is used as a switch it is operated in the Saturation and Cut-Off Region as explained above. When base current is removed the transistor becomes fully off, this stage is called as the Cut-off Region and the Base Emitter voltage could be around 660 mV. ![]() This stage is called Saturation Region and the typical voltage allowed across the Collector-Emitter (V CE) or Base-Emitter (V BE) could be 200 and 900 mV respectively. When this transistor is fully biased then it can allow a maximum of 100mA to flow across the collector and emitter. To bias a transistor we have to supply current to base pin, this current (I B) should be limited to 5mA. ![]() The maximum amount of current that could flow through the Collector pin is 100mA, hence we cannot connect loads that consume more than 100mA using this transistor. Note: Complete Technical Details can be found at the BC547 datasheet given at the end of this page.īC549, BC636, BC639, 2N2222 TO-92, 2N2222 TO-18, 2N2369, 2N3055, 2N3904, 2N3906, 2SC5200īC547 transistor has a gain value of 110 to 800, this value determines the amplification capacity of the transistor.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |